Fixes:
- Added Feature: GEN5 fast cursor.
- Changed: Enable UIBC by default
- Fix: Invisible fast cursor with UIBC movement.
Upgrade Instructions:
- Download and save ScreenBeam Pro’s firmware (sbpro_fw_x.x.xx.x.zip) to your Windows desktop or C:\ drive.
- Use either WinZip or Windows Explorer to extract the zip file. You should see the "autorun" folder, the "install" file and this upgrade instructions guide.
- Insert your USB flash drive to an available USB port on your Laptop/PC.
- Copy both the "autorun" folder and "install" file to the top directory of the USB flash drive.
- Note: Do not use a portable hard drive. You should use a formatted FAT/FAT32 USB flash drive only.
- Make sure the HDTV connected to the Receiver is powered on and the correct HDMI input is selected.
- Note: You must disconnect all wireless devices (ultrabooks, smartphones and tablets) from the Receiver before upgrading the firmware.
- When the “Ready to Connect” screen appears, plug the USB flash drive into the Receiver’s USB Port.
- Wait a few seconds and the firmware upgrade will start automatically. You should see the Firmware Upgrade message appears on your TV.
- Note: The HDTV screen may go temporarily blank for a few seconds during the upgrade process.
- Warning! Do not power off the Receiver or remove the USB flash drive while the upgrade is in progress. This may cause the firmware upgrade to fail.
- When the upgrade completes, the “Ready to Connect” screen reappears on the HDTV, with the new firmware version information displayed at the bottom right corner.
- The ScreenBeam Pro Receiver is now upgraded. You can remove the USB flash drive from the Receiver.
תגובות לא נמצא